Quadcopter Full Frame


6,602

12

1

Introduction: Quadcopter Full Frame

Antonio Gomes received a Bachelor’s of Computer Science as well as a Bachelor of Communication an...

A little quadcopter frame I developed from scratch!

The mounts were made to fit cf2822 motors (22mm between holes) but they can be easily adapted to other models

Instructions It's pretty straightforward... and it only requires m3 screws!

bottom layer (board mount)
arms
board mount
cover

Done.. :)

I will post detailed instructions as soon as I actually fly it sometime next week

Required files attached!

Print on a uPrint SE Plus

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Be the First to Share

    Recommendations

    • Trash to Treasure Contest

      Trash to Treasure Contest
    • Rope & String Speed Challenge

      Rope & String Speed Challenge
    • Wearables Contest

      Wearables Contest

    Discussions

    0
    domi64
    domi64

    3 years ago

    nice and simple, Which 3D software have you used ?