Quick Deploy Paracord Bracelet

14,526

109

2

Introduction: Quick Deploy Paracord Bracelet

The quick deploy paracord bracelet is one of the most beautiful bracelets I made so far. Although it is made because of the fact that it is easy to disassemble and use as cord, I have made it because I like the bumblebee motive that the combination of yellow and black make.

This is one of the bracelets that I feature in my new book on paracord bracelets.

The bracelet is essentially made from two pieces of cord. After setting it up by making a basic slip knot on each of the cords we simply make a series of half hitches. We alternate making one with one color, the switch colors for the next half hitch.

The cord used for the core of the bracelet after the slip knot should be as long as you want your bracelet to be.

When we reach the top, we will be left with two loops. We slide one loop through the other and tighten the outer loop by pulling the cord of the same color at the other side of the bracelet.

We finish the bracelet with the use of the lanyard knot.

To undo the bracelet, remove the outer loop we tightened and pull on the lanyard knot.

Step 1: See How the Bracelet Is Made Below

Jewelry Contest

Participated in the
Jewelry Contest

Outdoor Survival Contest

Participated in the
Outdoor Survival Contest

Be the First to Share

    Recommendations

    • Exercise Speed Challenge

      Exercise Speed Challenge
    • Pocket-Sized Speed Challenge

      Pocket-Sized Speed Challenge
    • Super-Size Speed Challenge

      Super-Size Speed Challenge

    2 Discussions

    0
    Bban
    Bban

    5 years ago

    Do you by chance have the measurements for the bracelet? That would help a lot thx.