CNC - RF Shield for Electronic Tester

About: Hello, I'm working at large scale high-tech company. As part of my responsibility, I provide professional support for most electrical & electronic development activities in the company: • Planning, impleme...

Intro: CNC - RF Shield for Electronic Tester

This cover was created as RF shield for electronic board, 
which is being tested on "Bed of Nails" jig.
For this work was used aluminum plate 2mm thickness.
The shape was drawn in Dr.Engrave S/W (provided by Roland),
as per an original polycarbonate cover of Jig.
The folding was easily done with the guide lines - 0.4mm depth.
All the holes for support pins were drilled through the original
polycarbonate cover of Jig, so they were exactly placed on surface.
The milling work was performed on Roland EGX-350 CNC machine.

Share

    Recommendations

    • Plastics Contest

      Plastics Contest
    • Electronics Tips & Tricks Challenge

      Electronics Tips & Tricks Challenge
    • Audio Contest 2018

      Audio Contest 2018

    Discussions