CHECK OUT THIS SINGLE-BARRELED VERSION!
Cool! A knex ranger! It's actually break action too! Soooo...... Oh, right, you guys will be wondering about the range. Right? Well, It gets about 40-45 feet (perfect for a shotgun)
One more thing, if you liked or even loved my break action rifle, you'll love this too! It's pretty much the same, except not as big and not as much range.
PROS AND CONS!!!!!
two shots (yellow rods)
Has bullet locks so the bullet doesn't fall out
uses three broken pieces (two are optional)
Uses a lot of hinges and blue clips
Well, Don't Waste Your Time Reading This! Get The Parts And Build The Gun!
Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.
Step 1: PARTS LIST!
Full credit goes to knexsuperbulderfreak!!!! Go subscribe to him!
gray(should be black):2
cut white rod:1
And also: two cut blue rods (for comfort)
Step 2: The Body Parts
Okay, let's start by making the plates!
Picture 1: Make one of these
2: Make the same plate you just made and put blue rods on it
3: The broken blue rod you should get. Make this twice.
4: Make this one. Note the broken rods.
Done! Next step!
Step 3: The Insides
These are, well, the insides! If you want your gun to work then make this stuff! (trigger included in this step)
Picture 1: Make this stuff! (make everything twice)
2: Make the trigger
3: Get those rods, you will need them later.
Step 4: Putting Together!
That was quick! Almost done! This step is kinda tricky...
Picture 1: Take the plate with the broken blue rods and take the broken blue rods off and put them on the plate with all of the uncut blue rods. Okay now you can take the plate with the blue rods on it and put the insides on!
2: Get the plate with the cut white rod on it and put two blue spacers on it.
3: Put that plate on. Look at how the blue spacers go.
4: what you SHOULD have so far.
5: put the other insides on what you have so far.
6: put the last plate on.
7: take one of those white rods you have and put it in the gun with those parts on.
8: lay those parts that were sticking up on the other part of the gun and put white rods in those parts too.
Step 5: Extras
Okay, here we will make the firing pins and some other stuff.
Picture 1: the pins and the trigger.
2: Get this stuff
3: Put the elastic on and put that part on. (The elastic should be on the bullet locks too.)
DONE!!!!!! We just need to put elastics on the gun and load it!
Step 6: Elastics and Loading
Well, you are almost finished your knex ranger!
Let's put the elastics on.
Picture 1: Add elastics!
1: Pull pins back together.
2: Break open gun.
3: Get two yellow rods and put them in the barrels.
4: Push yellow rods all the way in. They won't fall out.
5: Close the gun up.
6: PULL TRIGGER TO CONQUER THE WORLD!!!!