For a whisky tasting I organised I wanted to aid the tasters with their tasting.
So I created 'Rate Your Whisk(e)y' coasters.
Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.
Step 1: Prepare for Lasercutting
I created the coasters in inkscape.
Used rectangles with round edges. (Dimensions 90-120 mm each)
Inserted the picture after.
Step 2: Start Lasercutting
After I created the file. It was ready for lasercutting.
(Notice: The file might need some tweeking depending on your specs)
I used MDF 4mm as base (300-600 mm)
It took me about an hour to complete.