Introduction: Ray and Jeffery's Robot "The Rocket"
This is our robot "The Rocket". Jeffery and I built this robot in our Robotic Class. We were so excited when we did this. We spent three classes periods to finish it. We won the Robots' battle in our class, we lost one round to the "Dusty", however, we did not give up and fought again. Finally, we got the champion.
Step 1:
We prepared all the materials.
Step 2:
Step 3:
Then we started to make the shovel, we put a lot of connectors to make it stable.
Step 4:
.We also put a hollow square to make it large and more easy to tilt the enemies.
Step 5:
Step 6:
Step 7:
Then we got out the little connectors.
Step 8:
Then we put a beam in front of it that makes sure it didn’t flip.
Step 9:
Step 10:
We first used several strips to put the engine.
Step 11:
We used four engines on this robot.
Step 12:
After that we started to build the body part of the robot.
Step 13:
Then, we add an extra layer on that using the 3 rectangle shaped pieces.
Step 14:
Plug them on our robotic body
Step 15:
Solidify our robotic base.
Step 16:
PUT THEM TOGETHER
Step 17:
We put a structure of two long pieces and two small piece under the engine to stable them.
We did it on all of our engines.
Step 18:
We stabled it pretty well using a lot of connectors, this makes sure it doesn’t fall apart.
Step 19:
We put three tires together.
Step 20:
SIX BIG TWO SMALL
Step 21:
We stabled it pretty well using a lot of connectors, this makes sure it doesn’t fall apart.
Step 22:
Receiver
Step 23:
Finally, we put our battery and receiver on, and we also makes sure the battery is full.
