Remote Controlled LED

Introduction: Remote Controlled LED

This is a very simple build. All you need is

  • 1x brushed ESC
  • 1x 12 Volt LED
  • 1x 3s Lipo
  • 1x RC Transmitter and Receiver

With the brushed ESC you will be able to remote controll the brightness of the LED.

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: Connect the Brushed ESC

  1. Connect the brushed ESC to the RC receiver
  2. Connect the motor cables of the brushed ESC to the LED. The red cable goes to the positive pole (+), the black to the negative pole (-).
  3. Power the brushed ESC with a 3s Lipo

Power up - now you are ready to remote control with your RC transmitter the brightness of the LED

Be the First to Share

    Recommendations

    • Trash to Treasure Contest

      Trash to Treasure Contest
    • Raspberry Pi Contest 2020

      Raspberry Pi Contest 2020
    • Wearables Contest

      Wearables Contest

    Discussions