Remove the Clicking Noise in a Nerf Vulcan EBF-25's Tripod

17,071

7

7

About: I am a dinosaur that likes to build and modify things but I am confined in the not-so-DIY environment of Malaysia.

This is a instructable to remove the clicking noise in a Nerf Vulcan EBF-25's tripod (obviously???).Its very irritating that the Nerf Vulcan EBF-25's tripod clicks every time you turn it a bit, which will tell people where you are during a Nerf War.

Step 1: Things Needed:


1.Phillips head screwdriver
2.Your fingers
3.A Nerf Vulcan EBF-25's tripod(duh...)

Step 2: Step 1

Unscrew the four screws on the top of the tripod

Step 3: Step 2

Remove the other four screw under that

Step 4: Step 3

Remove the small piece of plastic that I have noted in the picture.Don't remove the big piece of plastic that keeps the tripod folded.

Step 5: Step 4

Remove the silver screws that I have noted in the picture and remove the spring and the piece of plastic that clicks when you tilt it up and down.

Step 6: End

Screw back the tripod and your done!

Share

    Recommendations

    • Make it Glow Contest 2018

      Make it Glow Contest 2018
    • Toys Contest

      Toys Contest
    • Big and Small Contest

      Big and Small Contest

    7 Discussions

    0
    None
    bwool1Tyrfing

    Reply 7 years ago on Step 4

    Try mousing over the little white plus sign in the pic... Yeah, that note.

    0
    None
    MAVREV13

    8 years ago on Introduction

    this is good its not that helpfull unless ur sneeking up on some one i give it a 3.5 that was cool though.