Introduction: Renew Motorcycle Winter Gloves
Riding a bike in the winter require good gloves.
So these gloves worked grate for a few years and last year watte resistance fail totaly.
I bought new ones but it was hard to give up the old ones.
So i decided to renew them.
Old winter gloves
Fabric (very sharp) Scissors
Thick nitrile (?) Gloves
Strong sawing maching or a friend with one :')
Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.
Step 1: Cut and Open
We need to open the bottom end of the glove in order to remove the inside.
Step 2: Take It Out!
Pull the lining inside glove out stringly and slowly it might be glued to the outside.
Step 3: Clean the Old
Now you can see the old and worn out water resist lining.
Take it off and give it a good clean, and also from the inside of the "shell".
Step 4: In and in We Go
Put the lining on your hand
Pull the nitrile glove over the lining
Pull the shell over the nitrile glove
Step 5: Saw and Close
Cut and saw the bottom end
Have fun ;')
Participated in the