Rubber Band Gun Hack

12,388

15

10

First you might want want to use the kind of gun that is displayed

What you need:
rubber band gun,
rubber bands,
sharp razor,
a little time

Step 1: Step 1

With the razor in your hand take a look up the underside of the gun above the trigger guard.

Step 2: Step 2

Cut off a small notch above and behind the trigger that keeps the gear from turning.
Now load on as many rubber bands as you can and watch them fly all at once.

Step 3:

The finished product should look like this.

Share

    Recommendations

    • PCB Contest

      PCB Contest
    • Cardboard Challenge

      Cardboard Challenge
    • Toys Contest

      Toys Contest

    10 Discussions

    0
    None
    rimar2000

    6 years ago on Introduction

    Good work!

    I think you could easily modify this design to launch the bands one by one. That would be funnier.

    0
    None
    hunter13

    8 years ago on Introduction

    I modded the one gun because it didn't work properly. It worked so well I modded the other gun.

    0
    None
    knexinventer

    8 years ago on Introduction

    my tommy gun if there is more than 12 bands it goes full auto not modded