Santa Ornament

I am a 7th grade student at Eagle Hill middle school. This is the ornament I created for my Technology class. A little bushy bearded Santa Claus.

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: Create Artwork

I hand drew this picture on paper, then put it into Autodesk Inventor and traced out the Santa Claus. I then extruded each part of the Santa Ornament so that certain parts would be raised higher than others.

Step 2: Scale the Drawing Down

I drew this ornament too large. The x dimension needs to be 2.11mm, y dimension needs to be 2.75mm and the z dimension needs to be set to 7.0mm.

3D Printed Ornament Design Challenge

Participated in the
3D Printed Ornament Design Challenge

Be the First to Share

    Recommendations

    • CNC Contest

      CNC Contest
    • Make it Move

      Make it Move
    • Teacher Contest

      Teacher Contest

    5 Discussions

    0
    None
    peppypickle

    4 years ago on Introduction

    great job! and welcome to the Instructables community! I really like your ornament!