Semi-goose Gun Mod

2,556

1

12

Introduction: Semi-goose Gun Mod

Flie-Ing GOOse's semi-goose gun was one of the first K'nex guns I built, but I wasn't totally satisfied with it so I decided to do some nice, heavy modding. I turned pretty much the whole front half of the gun upside-down. It doesn't look as much like a real gun, but it works much better.

This is my first instructable, so bear with me.

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: The Chamber

The bullet chamber is probably one of the most important aspects of the mod. I used two single-slot gray connectors with the tops cut off to add stability.

Step 2: The Trigger

The trigger design is pretty much the same, but it needed to be reinforced because I used a powerful rubber band that put too much stress on it.

Step 3: Handle and Butt Area

Not much to change here, just wanted to be thorough.

Step 4: Firing Pin and Rubber Band

This is easy.

Step 5: Finishing Up

That's pretty much it. Enjoy!

Be the First to Share

    Recommendations

    • Backyard Contest

      Backyard Contest
    • Finish It Already Speed Challenge

      Finish It Already Speed Challenge
    • First Time Author Contest

      First Time Author Contest

    12 Discussions

    0
    Kaiven
    Kaiven

    Reply 10 years ago on Introduction

    ARE YOU SERIOUS?! That comment is TWO years old! Stop bringing up old topics...If you have seen anything I do now a-days, you will see that I am two years more mature than two years ago.

    0
    Miles Tails Prower
    Miles Tails Prower

    Reply 10 years ago on Introduction

    Even when I was really young I didn't even do that. Lol and does it matter if you post things on old topics? If you don't spam or something like that then I think it's okay to post on old topics.

    0
    Kaiven
    Kaiven

    Reply 10 years ago on Introduction

    I heard before it does something with the Instructables system, or just annoys the commenter. Idk for sure, but I just heard not to do it.

    0
    pls
    pls

    12 years ago on Introduction

    the firing pin makes cocking fun

    0
    Namlem
    Namlem

    Reply 12 years ago on Introduction

    I don't remember saying it was...

    0
    Namlem
    Namlem

    Reply 12 years ago on Introduction

    Mainly, I didn't like that the clip was on the bottom. It made loading it annoying because you were fighting gravity when you pushed the rods up into the chamber. It caused it to jam a lot. The other modifications are just for style and comfort.