Sequino

994

12

4

Introduction: Sequino

Hii Friends Today i will Make Sequino

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: COMPONENTS AND SUPPLIES

Arduino Nano R3
× 1
nano cnc shield
× 1
stepstick a4982
× 3
hall sensor
× 1
ir reflective sensor
× 2
24byj48 1:64 stepper motors
× 4
3mm 2gt belt
× 1
602 bearings
× 12

NECESSARY TOOLS AND MACHINES

3D Printer (generic)
09507 01
Soldering iron (generic)

Step 2: Description

This project is a continuation of my quest to build a robotic clock which can write and rewrite the time continuously day in and day out and keep going doing it. My first attempt with doodle clock was a failure due to the marker drying up and the second attempt with doodle#2 failed as the display got scratched very soon .

This clock was inspired by my daughters t shirt with the pattern changing sequin cloth glued to it. After getting some stock fabric from a vendor i figured out the size of the clock based on the minimum resolution of the cloth . The fabric has circles of 5mm stitched 3 mm apart. Also another limit of the clock was my printer bed size of 245x170mm .

Step 3: Details

https://youtu.be/6jpsiIsMG8U

Step 4: The Kinematics

The kinematics of the clock consists of a mix of h-bot and Cartesian system. The y axis consists of the two rings on the extreme ends of the clock driven by 2 24byj48 motors . The rings are basically gears constrained in outer rings similar to a hubless wheel. The x-axis consists of a strut holding the two rings together and driving a belt routed on a h-bot based path. The belt is driven by two motors. The motors when moving in the same direction move the pen carriage left or right on the x-axis while when then move in the opposite direction move the pen up or down.

Step 5: Figuring Out the Cloth Backing



The Sequin cloth consists of disks which are stitched to a a fabric backing. The Disks flip easily with a finger as they are mounted on a t-shirt or a bag which has a soft backing .But the moment i mounted it on cylinder it stopped flipping as the disks got over constrained by the hard backing . First i tried a ribbed structure as a backing with the fabric stretched on it. It worked but made it very complicated to construct.

Finally i figured it out that a simpler way was to just add a 3 mm sponge as a backing to the cloth to give the disks the freedom to flip.

Step 6: The Tip of the Pen


The tip of the pen was very tricky to figure out. Getting a material to act like the tip of a human finger is not very simple. The disks are very slipper and need just the right friction to flip them. The final solution was tip make of Tpu with a split hook.
Thanks 😊

Step 7:

Be the First to Share

    Recommendations

    • Trash to Treasure Contest

      Trash to Treasure Contest
    • Raspberry Pi Contest 2020

      Raspberry Pi Contest 2020
    • Wearables Contest

      Wearables Contest

    4 Discussions

    0
    Penolopy Bulnick
    Penolopy Bulnick

    13 days ago

    This looks fun! Do you have a video?

    0
    Ratty Bunyip
    Ratty Bunyip

    Reply 10 days ago

    My thought as well : it is on YouTube - search "Sequino".

    0
    NirL
    NirL

    2 days ago

    nice job!
    can you add the plans for the parts and the code you used??? Might make it more accessible to others :)
    thanks for sharing