Service Kobalt Weed Eater Head

3,326

1

1

Intro: Service Kobalt Weed Eater Head

Today, while weed eating, I managed to get a piece of wire wrapped around the drive shaft of my weed eater. Taking the head unit apart was quite simple. The steps are documented below for anyone who needs to open up their kobalt weed eater.

Tools Needed: 1 Philips head screw driver. 1 20T Torx screw driver.

First, remove the trimmer guide (the silver metal bar that flips up/down). Just pull it out of the holes that it fits in. Next remove the two philips head screws holding the trimmer guard in place. Slide the guard off. Now remove the torx screws. Notice that removing the guard exposes two more torx screws. Once all the screws are removed, the motor housing comes apart easily.

Share

    Recommendations

    • Furniture Contest 2018

      Furniture Contest 2018
    • Audio Contest 2018

      Audio Contest 2018
    • Electronics Tips & Tricks Challenge

      Electronics Tips & Tricks Challenge

    Discussions