Simple Button Battery Holder

Introduction: Simple Button Battery Holder

About: My name is Joe(obviously). I'm home schooled and my favorite subject is Science. I love anything with a screen or a transistor in it.(:P) I do a paper route every day at 5:30 in the morning. I like cooking d...

This instructable will show you how to make a button battery holder.

Step 1: Get Your Supplies

First, gather your supplies. You will need: Mini clothespin, two wires, and a hot glue gun.

Step 2: Glue Wire to Bottom of Teeth

Glue the wire to the inner bottom part of the clothespin.

Step 3: Glue Other Wire to Top of Teeth

Then glue the other wire to the top part of the clothes pin.

Step 4: Finished

Now you have finished your button battery holder! Thanks for looking!Please commet.

Be the First to Share

    Recommendations

    • Puzzles Speed Challenge

      Puzzles Speed Challenge
    • "Can't Touch This" Family Contest

      "Can't Touch This" Family Contest
    • CNC Contest 2020

      CNC Contest 2020

    4 Discussions

    0
    holymoses
    holymoses

    5 years ago on Introduction

    This piece is not very elaborated, but even if it was like others this way is quite risky for shorting the cells.

    Just a little short circuit due to overlapping cable and the voltage will run to empty very quickly.

    0
    souichi
    souichi

    10 years ago on Introduction

    that is kind of hard because it may not conduct electricity due to the hot glue gun

    I just glued the wires to the top of the clothes pin and the bottom part too.(See the picture)

    instruct2 011.jpg
    0
    lemonie
    lemonie

    10 years ago on Introduction

    What's your technique - hot glue - wire - close peg?
    This is the tricky bit, how did you do it?

    L