Simple IR Remote Tester Circuit.

2,271

14

2

Introduction: Simple IR Remote Tester Circuit.

Hello everyone, In this instructable we will be going to create a simple IR remote tester, that flickers LED whenever any button on IR remote is pressed.

Step 1: Gather the Parts

  • A breadboard
  • A LED
  • A 220ohm resistor
  • A TSOP382 IR receiver
  • 2 AA batteries
  • Some jumper or hookup wires

Step 2: Wiring

Hookup all the components according to the circuit diagram shown above.

Step 3: Done

Now, When you press any button on the IR remote, The LED flickers.

Thanks for viewing.

Please write your questions or suggestions below.

Makerspace Contest

Participated in the
Makerspace Contest

Be the First to Share

    Recommendations

    • Mason Jar Speed Challenge

      Mason Jar Speed Challenge
    • Bikes Challenge

      Bikes Challenge
    • Remix Contest

      Remix Contest

    2 Discussions

    0
    wold630
    wold630

    4 years ago

    So simple! Thanks for posting your very first project!!

    0
    kitty 1234
    kitty 1234

    Reply 4 years ago

    Thanks for your feedback