Simple IPhone Mount for a Tripod

About: I love Tinkering, Slacklining, Climbing, Longboarding, Skateboarding, and Sleeping.


What you need:
-Scissors
-Knife
-Empty tape roll

Step 1: Cut Slot

First, cut a slot in the tape roll big enough for your phone, but small enough so the roll pinches each side of the phone.

Step 2: Cut Hole

Now, cut a hole in the bottom with your knife by twisting the knife in a circle to form a hole. Make sure the mount fits the hole, don't make it to big.

Now...You're done! That's how easy it is. It is also easy to make modifications on it so, fell free to mod your new tripod phone mount!

Please VOTE for me in the camera contest.

Share

    Recommendations

    • Big and Small Contest

      Big and Small Contest
    • Make it Glow Contest 2018

      Make it Glow Contest 2018
    • PCB Contest

      PCB Contest

    3 Discussions

    0
    None
    Tomfhowe

    6 years ago on Step 2

    so, would this mess things up if it touches the screen? I mean, would it constantly be choosing your autofocus/exposure point for you?

    1 reply
    0
    None
    Krayzi99Tomfhowe

    Reply 6 years ago on Introduction

    I'd have to say "no". The touch screen on the iPhone differs from that of the DS, car panel, etc.. the iPhone screen goes off of conductivity between each part of it. I don't completely understand it myself. but, since the plastic has no conductivity, no. It would not affect the screen's touch input. However, it would get in the way. REALLY bad.