Simple Pvc Quiver

Introduction: Simple Pvc Quiver

Step 1: Materials

3 inch width pvc pipe Belt from old bag Sand paper Hot glue End cap

Step 2: Measure Your Pvc Pipe

A good length for a quiver is about 5-6 inches shorter than the arrow

Step 3:

Sand the pipe till its smooth ( i used 2different grit for it 80 and 600)

Step 4: Add Tour Belts

Now glue the belt in the inside of the bottom, And for the top, get a piece of belt and glue it in the inside of the pipe

Step 5: Do Not Glue in on the Outside Yet

Put your belt through the piece that u just glued. Now glue the piece on outside of the pipe

Step 6: Add Sponges

Ad a iece of sponge in the removable lid for the broad heads

Step 7: Decorate!

Be the First to Share

    Recommendations

    • Lighting Challenge

      Lighting Challenge
    • Metalworking Contest

      Metalworking Contest
    • Puzzles Speed Challenge

      Puzzles Speed Challenge

    3 Discussions

    0
    litgamer
    litgamer

    1 year ago

    how much was the prodject

    0
    interestedturtle
    interestedturtle

    6 years ago

    How many arrows does this hold

    0
    gizmomonki
    gizmomonki

    Reply 6 years ago on Introduction

    im not sure coz i didnt properly chercked with proper arrows, but it held 20 1centimeter width stick