Introduction: Simple Axial Flux Motor (Brushed)
My homemade Axial Flux motor using parts from old computers.
Coils were hand made.
Two magnets from a hard drive.
Brushes are made using copper sheet & copper wire.
Motor rpm is about 200 at 3V 500mA (Last Image)
CD as coil holder.
It can easily get over 1500rpm at 12V & as this is a brushed motor no controller is needed.
This is my second test build of axial flux motor.
In my next motor build I will add a step by step build guide with some better clear photos.(As my camera is having a focusing problem )
YouTube video -
( Please help me to buy suitable magnets for my next motor build.
My PayPal email - email@example.com )
Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.