the first thing I want to say is that I have entered this instructable in the knex contest so please vote.
Otherwise, I first made a eggbeater you can find the instructions here.
Then I got interested in knex mixers so I just had to make one for myself this is what it turned out to look like (above) it is the eggbeater I just made it to run by itself so you don't need to hold the eggbeater.
Well are you ready to make a small knex mixer?
Then lets get started!
Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.
Step 1: MODIFICATION
See that red connector which I am pointing at in the first picture?
Yeah well you'll see three more like that one.
You have to replace those for white connectors.
Afterwards it should look like the second picture
Step 2: MIXER HOLDER
Now make these.
Step 3: MIXER HOLDER
Step 4: MIXER HOLDER
Now put those together.
And build these parts on.
Then put a small bowl in between them.
Step 6: MIXER HOLDER
Make four of these (top) and put them on the holder (bottom)
Step 7: MIXER HOLDER
Put a red rod between each of the yellow connectors like this.
Step 8: THE WHOLE MIXER
Now put them together like this.
Step 9: You Are Done
Thank you for looking at this instructable and again please vote for me.
If you made one then post it in the comments bellow and I will add it to this step.
Participated in the