Snowman

This how you make the ornament.

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: Step 1

Step.1 Create three spheres, make a 1in., a .75in and .5in.

Step 2: Step 2

step2. Stack the three spheres on top of each other the largest on the bottom and the medium in the middle and the smallest on top.

Step 3: Step 3

step.3 Draw a tree using the line. then extrude the tree.

Step 4: Step 4

step.4 create a oval base for the ornaments to sit on. snap the tree on the base.

Step 5: Step 5

step.5 Make a cylinder of your choice for the arms and chaff the edges so they are round.

Step 6: Step 6

step.6 Make smaller cylinder so they are small enough for the eyes.

Step 7: Step 7

step.7 Make the cylinder the same size for the mouth and buttons.

Step 8: Step 8

step.8 Put the snowman on the base next to the tree.

Step 9: Tree

How to make the tree using 123design.

Step 10: Step 1

step1 Draw a tree outline using line using you own lengths.

Step 11: Step 2

step 2 Extrude the tree so it is now 3d.

Step 12: Step 3

Step 3 set the tree standing up on the base so your tree and snowman are both on the base.

3D Printed Ornament Design Challenge

Participated in the
3D Printed Ornament Design Challenge

Be the First to Share

    Recommendations

    • CNC Contest

      CNC Contest
    • Make it Move

      Make it Move
    • Teacher Contest

      Teacher Contest

    Discussions

    0
    None
    seamster

    4 years ago on Introduction

    Looks good! Thanks for sharing your ornament, and good luck in the challenge!