Solder Fume Vent From an Old PSU

Introduction: Solder Fume Vent From an Old PSU

About: started learning electronics back when I was 12.

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: The Main Unit

So majority if us hobbyists may have som old PC PSU units that are broken and just laying around in our boxes. And seeing alot of solder fume vents that are out there, you need to build it. But here's a simple way of doing that

Step 2: Gut It Out!

I already removed the pcb and the components of my power supply and just left the fan.

Step 3: Connecting the Fans

I don't want to cut off the ends of the fan so I just took a wire and just made a pin and soldered it in a scrap pcb laying around.

Step 4: Sticky Tac!

I just used sone sticky tac to stick it in the enclose. For the reason that it's what's in my drawer and is closer and I can't find my hot glue gun.

Step 5: You're Done!

Now stop inhaling those fumes and stay safe!

Be the First to Share

    Recommendations

    • Backyard Contest

      Backyard Contest
    • Silly Hats Speed Challenge

      Silly Hats Speed Challenge
    • Finish It Already Speed Challenge

      Finish It Already Speed Challenge

    Discussions