Speaker Helmet

This project shows you how to instal TV speakers into an Arduino

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: Necessities

The things you shall need, are
A helmet
An arduino
7 wires
An 8 ohm resistor
A soldering iron
And super glue

Step 2:

Strip the wires from the speakers

Step 3:

Solder the extra wires to the speaker wires, then solder the resistor to the non ground wires

Step 4:

Put the ground wire into the ground slot on the analog side, and the resistor into the 8th slot of the arduino.

Step 5:

Tape or glue the speakers to the inside of your helmet wherever you may please

Step 6:

Next tape or glue (whichever you please) the arduino to wherever you want

Be the First to Share

    Recommendations

    • Made with Math Contest

      Made with Math Contest
    • Multi-Discipline Contest

      Multi-Discipline Contest
    • Robotics Contest

      Robotics Contest

    Discussions

    None
    seamster

    4 years ago on Introduction

    How does the helmet feel with the speakers in there? It looks like they might be in the way. Are they?