Spiral Fidget Spinner

Introduction: Null

The spinner is setup for a 22mm diameter wheel bearing and (6) 1/2 inch ball bearings. The spiral design is sure to capture the eyes of everyone around you! The print time is 2 hours according to S3D.

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Be the First to Share

    Recommendations

    • Trash to Treasure Contest

      Trash to Treasure Contest
    • Rope & String Speed Challenge

      Rope & String Speed Challenge
    • Wearables Contest

      Wearables Contest

    Discussions