Spiral Spinner

Introduction: Null

This design is setup for a 22mm diameter wheel bearing with (6) 1/2 inch ball bearings. The spiral design is sure to capture the eyes of people around you! this will take around 2 hours to print according to S3D.

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Be the First to Share

    Recommendations

    • Tiny Speed Challenge

      Tiny Speed Challenge
    • Woodworking Contest

      Woodworking Contest
    • Trash to Treasure Contest

      Trash to Treasure Contest

    Discussions