Just a basic stock for any gun that you can get it on .
Low piece count and comfortable.
Get building :)
Step 1: Piece Count..
Rods :
Red rod = 2
Blue rod = 9
White rod = 6
Green rods = 4
Connectors :
Yellow connectors = 5
Green connectors = 8
Orange connectors = 11
Red connectors = 5
Misc :
Blue spacers = 20 (or you can replace with more orange connectors)
Red panel = 2
Step 2: Stock Rail Connector
From stock to gun ... Simple ...
Step 3: Stock End
Follow pictures ...
Pic 1 = Build this 2 times
Pic 2 = Build this 3 times
Pic 3-6 = Stack with as shown and connect with blue connector
Pic 7 = Get red panel
Pic 8 = Connect red panel as shown
Pic 9 = Get another red panel
Pic 10 = Connect on as shown
Pic 11 = Jam a white connector in where shown
Pic 12 = Connect to rail
Add to your gun :)
6 Discussions
9 years ago on Introduction
It's not so sturdy as the others, isn't it?
Reply 9 years ago on Introduction
yes it is if not better like the rail is improved by orange conns and spacers, and the butt is solid, depends on the gun
Reply 9 years ago on Introduction
Yes, the butt is solid and it would be much worse if the orange connectors weren't there, but the reason why it isn't sturdy is because of the joints. There are two rods connected to the stock and two are connected to the knex gun. If you could change that into 4 rods on every side, it would be much, much more sturdy.
Reply 9 years ago on Introduction
well maybe yes i might look at that but by that ull have to change the gun and butt :S
9 years ago on Introduction
no i dont like the stock either
Reply 9 years ago on Introduction
ur comment mate but i like it