Sugru GoPro Screw

Introduction: Sugru GoPro Screw

About: I like to design things, and build things, and hack things.

Instructables sent some Sugru to Milwaukee Makerspace for the July 2013 Build Night and I made a nice screw for my GoPro.

I used an M5 x 40 bolt and molded the Sugru around it to act as a grip so I can easily screw it into place with my fingers.

I'm using it with a 3D printed tripod mount I made, since the stock bolt that GoPro makes is just a little too short.

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Be the First to Share

    Recommendations

    • Trash to Treasure Contest

      Trash to Treasure Contest
    • Raspberry Pi Contest 2020

      Raspberry Pi Contest 2020
    • Wearables Contest

      Wearables Contest

    Discussions