Super Long Irwin Clamp Mod

Introduction: Super Long Irwin Clamp Mod

This is a very easy mod to make a super long (3') clamp by using parts from smaller clamps. The little collar/pin is tapped out of the smaller clamps and the handle grips are slid off. A flat piece of stock can be had from most hardware stores for $5 or less (1/8" x 1/2"). The handle grips slide right on and can also be used as spreaders.

Thanks for taking a look.

https://www.youtube.com/watch?v=qhQYxbwZgV8

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Be the First to Share

    Recommendations

    • Magnets Challenge

      Magnets Challenge
    • Snow Challenge

      Snow Challenge
    • Wearables Contest

      Wearables Contest

    Discussions