Super Sniper Knex Target

Do you want a knex target that swings when you hit it? Are you too pro of a sniper for other targets? then try my new Super Sniper Target! Its Simple AND effective!

Step 1: Make the Base

For the base you will need 6 grey rods, 2 red or grey connectors and 8 purple or silver snap together connectors. assemble as shown.

Step 2: Make the Axle

For the axle you will need 2 red or green rods, 16 grey spacers, 2 white or black snowflake connectors, 1 orange or brown connector and 2 tan or dark tan cap connectors( use them after you assemble the whole thing. Assemble as shown

Step 3: Make the Target and Counterweight

These are to be added to the snowflake connectors on the axle. They are made with 4 snowflake connectors, 10 green or black rods, 4 blue or silvery blue rods, 4 white or silver rods, 8 purple or silver snap together connectors and 6 red or grey connectors. Assemble as shown.

Step 4: Put It All Together!

Put the targets on the axle and then put the axle on the base. after putting the axle on, then attach the 2 tan clips on the outside ends of the axle as shown. Now aim at the top and watch it swing!



    • IoT Challenge

      IoT Challenge
    • Gardening Contest

      Gardening Contest
    • Party Challenge

      Party Challenge

    16 Discussions


    9 years ago on Introduction

    i just shot this with the knexsayer the target shattered and the yellow rod i shot was stuck in the cardboard i put behind it to not damage my wall


    10 years ago on Introduction

    pretty good, try making the base more stable, but other than that 4*s man =D


    10 years ago on Introduction

    ann, its ok but i would not use something like this for the DD-27. the targets would shatter, and possibly break the pieces. i am going to just stick to cardboard. but not that bad, 3.5/5

    6 replies

    10 years ago on Introduction

    some times if you hit it with a really powerful gun at close range thn the targets will break but the pieces dont shatter.