Switching Using Transistor in Arduino Using TinkerCAD Circuits

Introduction: Switching Using Transistor in Arduino Using TinkerCAD Circuits

About: Mechanical Engineer

This project illustrates the use of Transistor as a switch using TinkerCAD circuits

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: Components Required

Arduino UNO (1 No.)

Breadboard (1 No.)

Resistor 1k ohm (2 No.)

LED (1 No.)

Transistor (1 No.)

Jumper wire (3 No.)

Step 2: Breadboard Diagram

Make connections as shown in the breadboard diagram

Step 3: Block Code

Step 4: Start Simulation

Click Start Simulation to see the action

Step 5:

Be the First to Share

    Recommendations

    • Backyard Contest

      Backyard Contest
    • Silly Hats Speed Challenge

      Silly Hats Speed Challenge
    • Finish It Already Speed Challenge

      Finish It Already Speed Challenge

    Discussions