Introduction: The Guitar Kill Switch
Warning if you break or damage your guitar I am not reliable
Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.
Step 1: Materials
One momentary switch
Some 22 gauge wire
A soldering iron
A screw driver
Step 2: Step 2
Now turn the guitar over and find the volume/gain cover and unscrew it
Step 3: Step 3
Now get the drill and drill a hole in the guitar close to the volume pot so you can fit the switch
Step 4: Step 4
Now put the switch in the guitar and put the screws on. Now get the wire and cut about 3 inches of wire (2 strips)
Step 5: Step 5
Now get the two wires ( you don't have to solder the wire to the switch because the switch has holes in the Leeds. Now solder the the wires to the yellow wire on the volume pot and the second directly to the volume pot itself .
I hope you guys like please leave comment and thx for viewing
Participated in the
Mind for Design