Introduction: The Sipriani Rifle
Check my White Tiger V2 Rifle too!
"Mods" by The_Builder, go to this link.
"Mods" by Kookoo For Knex, go to this link.
This is it: My Sipriani Rifle
It's a high-powered rifle that shoots about 35 to 110 ft depending on the amount of rubberbands
-Could give some physic damage when hit (DON'T FIRE THIS AT ANYONE)
It's very recommendable rifle.
Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.
Step 1: Piece List
70 green rods
47 white rods
4 red connectors
1 y connector
2 ball sockets
41 yellow connectors
4 grey 2slot connectors
2 white snowflakes
4 green connectors
12 blue rods
15 grey connectors
Step 2: The Chain
This part is not neccasery, but it just makes it look cool.
and this way, you can carry it.
Step 3: The Handle
This part is needed for comfort and for the safety of your fingers.
Step 4: The Rear
This part is for stablitity and for protecting your eye when sniping.
Step 5: Trigger
This part is for holding the rubberbands from flying everywhere!
Step 6: The Barrel
This is the most important and, finger torturing part that is needed for holding the bullet.
Step 7: Putting the Rifle Together
Pic 1:barrel + trigger
Pic 2:put them together
Pic 3:trigger + rear
Pic 4:put them together
Pic 5:chain + barrel
Pic 6:put them together
Pic 7:handle + trigger
Pic 8:put them together
Step 8: The Rubberband Holders
build these two.
Step 9: The Rubberbands
pic A: put the rubberband as shown
pic B: put the rubberband as shown
pic C: put on the rubberband holders as shown
Step 10: Ammo
they come in grey, black, white and blue.
Step 11: You're Done!!!
Well you've built yourself the Sipriani Rifle
Have freaking much fun with my gun!!!
1 Person Made This Project!
- goliver5 made it!