I had a little space in my room and I wanted a furniture that could fit there. Unfortunately I couldn't find something that would please me an also fit in that place. So I bought some MDF (Medium-density fibreboard) and decidet to make the furniture myself. 

            I've used Pro 100 software to design this unique piece of furniture. The cutting of the MDF boards was done by a furniture company after the specification I provided them. My work consisted in measuring where tho wholes would be, drilling them and assembling all the pieces togheter. It took me some time but I think it came out very nice.



    • Pie Contest

      Pie Contest
    • Trash to Treasure

      Trash to Treasure
    • Organization Contest

      Organization Contest

    6 Discussions


    5 years ago on Introduction

    Good job done,
    you mention the wood is MDF, how come is is cladded with a vineer? Can you buy off the shelf MDF with such design on it?

    Very nice. It looks better than much of the store-bought furniture out there.

    I hope the people at the furniture shop warned you about the need for pilot holes - especially when driving screws into the edge of an MDF panel.