USB Light

2,137

8

3

Introduction: USB Light

Parts:
- 5x 10mm LEDs
- 30 ohm resistor
- proto board
- USB 'B' socket
- hot glue OR liquid electrical tape

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Make It Glow Challenge

Participated in the
Make It Glow Challenge

Be the First to Share

    Recommendations

    • Backyard Contest

      Backyard Contest
    • Silly Hats Speed Challenge

      Silly Hats Speed Challenge
    • Finish It Already Speed Challenge

      Finish It Already Speed Challenge

    3 Discussions

    0
    hayden54
    hayden54

    5 years ago

    what power is the wall plug you are using to power the unit

    0
    chipper35
    chipper35

    8 years ago on Introduction

    The photos are pretty good, but maybe a few more "steps" might've been a nice touch......how does one find the "ground" on the usb cable, for instance?

    0
    crtn2
    crtn2

    Reply 8 years ago on Introduction

    sorry, but i created this instructable few days after i made this device. USB piout can be found on internet.