Introduction: Use Arduino CLI to Flash Arduino Board
Nowadays, Makers, Developers are preferring Arduino for rapid development of the prototyping of projects.
Arduino is an open-source electronics platform based on easy-to-use hardware and software. Arduino has very good user community. Arduino board design uses variety of controllers which includes(AVR Family, nRF5x Family and fewer STM32 controllers and ESP8266/ESP32). Board has multiple Analog and Digital Input/Output pins. Board contains USB to Serial Converter as well which helps to program the controller.
In this article we will see how to use Arduino CLI feature to program Arduino boards.
Arduino CLI is command line interface where we can write the code in any text editor and compile the code using commands in CLI interface and flash the board too.
Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.
Step 1: Code for CLI
Here is github which for arduino-cli
Step 2: Tutorial to Install CLI
Step 3: Required Components
Raspberry Zero W
Raspberry Zero W in India- https://amzn.to/33jHgAQ
Raspberry Zero W in USA- https://amzn.to/33jHgAQ
Raspberry Zero W in UK - https://amzn.to/33jHgAQ
Arduino Uno in India- https://amzn.to/2WmcLHU
Arduino Uno in UK - https://amzn.to/2WmcLHU
Arduino Uno in USA - https://amzn.to/2WmcLHU
Arduino Nano in India- https://amzn.to/2Jy1gYJ
Arduino Nano in UK - https://amzn.to/2Jy1gYJ
Arduino Nano in USA - https://amzn.to/2Jy1gYJ
Step 4: Software
Code and Software for CLI