The virtual dice is a project I came up with while experimenting with various Arduino ideas. It is very simple and anyone who can assemble a project can make this with my provided code. Enjoy!
Copyright (C) 2019 GreatMJH. All Rights Reserved. Available under CC-BY-SA license.
Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.
Step 1: Get the Parts
The following parts are required:
- Arduino UNO (or any other Arduino board, but the diagram is for UNO)
- 7x 240-ohm resistors
- 1x Push button switch
- 1x 1k resistor
- 13x Jumper cables
These parts can all be found from any major electronics retailers.
Step 2: Build the Circuit!
Build the circuit as per the diagram on a breadboard.
All LEDs have negative on the left side and positive on the right side.
Step 3: Upload the Code
Once you have assembled the circuit, you can now upload the code to your Arduino.
Step 4: Enjoy!
Thank you for following this Instructable. Please leave any suggestions in the comments and if I see them I will respond.