Introduction: WW2 K'nex Spitfire V3.0
Step 1: Making the Nose of the Plane
There is also a rubberband in the nose to give the prop a nice swing ,but you can also go for the upgrade whit a motor ,step 6. Right now could also do the Cockpit Upgrade ,step 7.
Some times there are more instructions in the notes so look there too.
Step 2: Making the Tail
The tail of the spitfire just follow the pictures and you'll be fine.
Picture 3 instead of blue bendable rod use normal rods. So the tail is in a better straight line.
Picture 6 the wheel is a 1 inch wheel of plastic.
Step 3: Making the Wings
Make 2 of these only one the opposite.
There is also another idea for the guns for that you need to take a look at step:8 more for the look.
Step 4: Pute It Al Together
Just follow the pictures. And the notes that go whit it.
Step 5: If You Want to Hang the Plane on the Ceiling Like Me.
It is best to use a simple nylon cord. When you cute a piece of it use a lighter to meld the ends. So the ends don't unravel (if that how you call it). And when the balance point as you like. Hang it up some where. I did it above my bed. Or do something else with it.
Step 6: The Engine Update
still better than a rubberband and much cooler and goes faster
Step 7: Cockpit Upgrade
This is the cockpit upgrade. I think it's a nice finishing touch.
Step 8: Little Changes
Little changes. Just fallow the pictures and notes in it.