Water Bottle Hampster Tunnel

3,548

2

7

An easy to make hampster tunnel made from 4 small water bottles.

Materials:
4 small water bottles
Crazy Glue
Permanent Markers

Supplies:

Step 1: Step 1. Cut Bottles

Cut bottoms off of bottles. Make sure you cut at the wide point on the bottom so that it has the largest opening possible.

Cut tops off bottles where it starts to curve.

Step 2: Step 2. Glue Bottles

Put a bead of crazy glue around the inside edge of the large opening of one bottle. Insert the small opening (where you cut the top off) of another bottle and hold in place while glue dries.

Repeat this with the rest of the bottles forming a tube.

Step 3: Step 3. Decorate!

take the markers and design to your liking.

Share

    Recommendations

    • Classroom Science Contest

      Classroom Science Contest
    • Party Challenge

      Party Challenge
    • Arduino Contest 2019

      Arduino Contest 2019

    7 Discussions

    0
    None
    reggaemon

    10 years ago on Introduction

    Woops. Finishing the thought above ... Don't leave it in the cage.

    0
    None
    reggaemonMattSwan

    Reply 10 years ago on Introduction

    The interior walls are smooth enough that the hampster can't sink it's teeth in. You just need to make sure the joints between bottles are bonded smoothly. That being said, the kids use it while playing with the hampster out of the cage. We don't leave it in the cage as it would likely check