Water Level Controller

Introduction: Water Level Controller

This project is about a fully functional water level controller using Arduino and Cayenne. The cayenne App displays the level of water in the tank and switches the motor ON when the water level goes below a predetermined level. The circuit automatically switches the motor OFF when the tank is full. The circuit also monitors the level of water in the sump tank (source tank). If the level in side the sump tank is low, the motor will not be switched ON and this protects the motor from dry running.

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1:

Step 2:

Step 3:

Step 4:

Be the First to Share

    Recommendations

    • Trash to Treasure Contest

      Trash to Treasure Contest
    • Wearables Contest

      Wearables Contest
    • Fix It Contest

      Fix It Contest

    Discussions

    0
    reachpavan
    reachpavan

    Question 2 years ago on Step 1

    what sensor was used and how deep was the tank