Weather Forecasting and Interfacing DHT11 Sensor With Mediatek Linkitone Board

3,868

60

4

Introduction: Weather Forecasting and Interfacing DHT11 Sensor With Mediatek Linkitone Board

In This Instructable, You Will Be Able To Do weather Forecasting using DHT11 Humidity and Temperature Sensor.

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: Requirements

Mediatek Linkitone Board
DHT11 Temperature and Humidity Sensor
Jumper Wires
USB Cable for Board

Step 2: Connections

VCC : +3V3 On Board
Out :D4 Digital Pin on Board
GND: Ground on Board

Step 3: Code, Compile and Run

Upload The Code, Import the header file attached above And You Can See The Output On The Serial Monitor Depending Upon The Environment Conditions.
Congratulations!!! You Have successfully Interfaced DHT11 with LinkIt One Board!!

Be the First to Share

    Recommendations

    • Backyard Contest

      Backyard Contest
    • Silly Hats Speed Challenge

      Silly Hats Speed Challenge
    • Arduino Contest 2020

      Arduino Contest 2020

    4 Discussions

    0
    corradini
    corradini

    4 years ago

    Am I missing something? Like: the header file and code?

    0
    ParthP23
    ParthP23

    Reply 4 years ago

    Apologies for the inconvenience think so it GT deleted will upload it soon

    0
    corradini
    corradini

    Reply 4 years ago

    Thanks! I'm looking forward to it!

    0
    ParthP23
    ParthP23

    Reply 4 years ago

    Uploaded!!!!