Whiskey Dispenser (Golf Cart)

Stripped down a couple of pumps and containers to make this for a buddy who loves golf..........and whiskey.

Step 1: Box

Built it out of 1/4" Baltic birch
Handles are maple
Spout is 1/2" stainless steel
Covered with carbon fibre

Step 2: Pump Assembly

Pump is located at the bottom, center.
Surgical hose runs through the stainless to about an 1" from the end.

Step 3: Free Standing

Step 4: Golf Cart Mode

Not shown is the center stub at the bottom of the box which fits in the center pocket on nearly any golf cart. The spouts line up with each cup holder.
3 golf tee holders and a cell phone pocket.

Share

    Recommendations

    • PCB Contest

      PCB Contest
    • Warm and Fuzzy Contest

      Warm and Fuzzy Contest
    • Safe and Secure Challenge

      Safe and Secure Challenge

    Discussions