Winter LED Hat

Introduction: Winter LED Hat

About: I love Raspberry pi, Nerf, Minecraft, 3D printing, and raspberry pie😁.

Hi! I'm Cameron. Welcome to my instructable on my DIY light up hat! It is very simple to make and use. Hope you enjoy!

Supplies:

1. hat (with rim around the edges)

2. this headlamp

3. battery pack

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: Dismantle the Headlamp

Steps:

1. Rip off the battery cover (it doesn't matter!)

2. Remove all the screws

3. Pull out the battery holder

Step 2: Remove the Circuit Board

Simple! Just pull it out (be careful!)

Step 3: Solder It!

See the battery + and battery - on the circuit board? Solder the battery holders wires onto it!

Step 4: Attach It to the Hat!

What to do:

1. glue the circuit board to the front of the hat.

2. glue the battery pack to the inside of the rim on the hat

(OPTIONAL) 3. put a piece of foam tape on top of the battery pack, the press the hat down on it.

Step 5: Enjoy!

There are no steps on this one! YAY! Just enjoy! (Some people count that as a step.)

Make it Glow Contest

Participated in the
Make it Glow Contest

Be the First to Share

    Recommendations

    • Trash to Treasure Contest

      Trash to Treasure Contest
    • Raspberry Pi Contest 2020

      Raspberry Pi Contest 2020
    • Wearables Contest

      Wearables Contest

    Discussions