DIY Wire Ring

About: "I am a crafty girl. I make things. Lots of things. I'll keep making things until my fingers fall off. Then I will grab my hot glue gun reattach those suckers & Make More Things." Kathy R. Jeff...

How to make the most adorable rings using only wire and a bead. They are adorable and they make great Valentines Day presents. Hope you enjoy.

Step 1: What You Need

What you need is:

26 GA 1/4 LB. (any color I used green)


Round bead of any color

Step 2:

Cut a length of wire about 7 inches long. Then string your bead on to it and leave it in the middle.

Step 3:

Place the bead and the wire on your finger and wrap the two strands around your fingers. Then take those two strands and wrap them around the bottom of the. For any help refer to pictures.

Step 4:

Wrap the last two bits of wire around the circle (as seen in picture 1 & 2)

Step 5: Finished Results

The finished rings turned out very well. I made 5 of them. I made one and it fit perfectly on my baby sister's hand (you can see it in picture 3) she loved it. I hope you enjoyed this instructable and don't forget to vote :)

Guerilla Design Contest

Participated in the
Guerilla Design Contest

On a Budget Contest

Participated in the
On a Budget Contest

Rings Challenge

Participated in the
Rings Challenge



    • 1 Hour Challenge

      1 Hour Challenge
    • Colors of the Rainbow Contest

      Colors of the Rainbow Contest
    • Frozen Treats Challenge

      Frozen Treats Challenge

    3 Discussions


    4 years ago on Introduction

    When my daughter was a kid she found my silver solder and used it up making jewelry.

    1 reply