Introduction: Wooden Etched Art
I wanted some simple art on my walls and so I tried this out. I made it at Techshop using the laser cutter.
Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.
Step 1: Design and Cut
I designed it in Corel Draw. It was cut using the Epilog Laser. I made 3 panels varying slightly.
Step 2: Paint and Hang
I slapped on some paint and used the blue Paper Tak stuff to mount it up on my walls. Squish the blue stuff in a ball and press it between the frame and the wall!