Introduction: Woodwork-Tool Holder
I am From Malaysia, Penang.. This is my 1st instructable..so..i hope you'll like it :) This is my finished product :)
Add a Teacher Note to share how you incorporated it into your lesson.
Step 1: Things You'll Need!
1: Some short and long nails
2: A few fibrewoods and long pieces of wood
3: "L" Shaped holders
4: A drill( Mine is a manual Hand Drill)
5: Biggest drill bit(for wood)
6: Some strength
7: Liquid nails glue
8: A lot of time :)
Step 2: I Dont Know What to Say
I dont know what to say..but..this is my picture of my finished product. I know...i am not good in instructing..but..i hope you will like it..
Step 3: Using the Hot Glue.
Arrange your spanners from Big to small or as you like..Then heat up the glue gun and just press it to mold it...remember, do this on a piece of glass..it will not stick to glass..
Step 4: Enjoy!!
Enjoy..see ya' in my 'next' instructble. Hope you'll successfully complete this project...if you have any pics of your finished product, feel free to post it in the comments..Thanks for visiting my instructable!