Working With Servo and Arduino in TinkerCAD Circuits

This project demonstrates working with Servo and Arduino in TinkerCAD circuits.

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: Objective

  • Rotate the Servo by Discrete angular positions (eg., 45 and 90 deg)
  • Rotate the Servo Continuous (eg., 0 to 120 and back)

Step 2: Components Required

  • Arduino UNO (1 No.)
  • Breadboard (1 No.)
  • Servo (1 No.)
  • Jumper wire (3 No.)
  • USB cable (1 No.)

Step 3: Breadboard Diagram

Make the connections as shown in the figure above.

Step 4: Block Code

Create Block codes as shown in the figure

Step 5: Start Simulation

Click Start Simulation to see the action

Be the First to Share

    Recommendations

    • Made with Math Contest

      Made with Math Contest
    • Multi-Discipline Contest

      Multi-Discipline Contest
    • Robotics Contest

      Robotics Contest

    Discussions