Working With Seven Segment Display Using Arduino

This project demonstrates working with Seven Segment Display and Arduino in TinkerCAD circuits .

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: Objective

To display digits 0 to 9 at a time interval of 1 sec.

Step 2: Components Required

Arduino UNO (1 No.)

Breadboard (1 No.)

Seven Segment Display (1 No.)

Resistor 1k ohm (8 No.)

Jumper wire (2 No.)

Step 3: Breadboard Diagram

Make the connections as shown in the figure above.

Step 4: Block Code

Step 5: Start Simulation

Click Start Simulation to see the action

Be the First to Share

    Recommendations

    • Made with Math Contest

      Made with Math Contest
    • Multi-Discipline Contest

      Multi-Discipline Contest
    • Robotics Contest

      Robotics Contest

    Discussions