Diy Shelf Division

Introduction: Diy Shelf Division

Hi this is my first instructable.

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: Gather the Parts

Parts:
Old transformer (From junk)

Tools:
Lighter (1)
Hot glue stick. (1)

(you could use hot glue gun instead of lighter)

Step 2: Pull Out the Plates

Take apart the transformer and save the plates.
Story I didn't took the photo of this process.

Step 3: Bend the Plates

Bend the plates as shown in the photo.
I used a heatsink for holding it in place.

Step 4: Mark the Positions and Place It

Place the glue as marked.
Stick it to the shelf.
I used 3 of them.

Step 5: Finally

Place a cardboard or glass sheet tight on the plates.
if the board is loose the plate may come off.
Hope you enjoyed this instructable.
I am participating in the hot glue challenge.
Vote for me.

I will upload my next instructable soon.

Hot Glue Challenge

Participated in the
Hot Glue Challenge

Be the First to Share

    Recommendations

    • Backyard Contest

      Backyard Contest
    • Silly Hats Speed Challenge

      Silly Hats Speed Challenge
    • First Time Author Contest

      First Time Author Contest

    Discussions