Introduction: Dynamite Ipod Clock and Charger
what your looking at is avery realistic dynamite ipod clock and charger this should take no more than 30 minutes to make this and the cost is very low i am working on a better one right now and will post it at a later date but this is a cool way to charge your ipod and im pretty sre none of your friends have one like it either have fun!
Step 1: Materials
Step 2: The Measuring
use the ruler to measure two feet on the cardboard tube
Step 3: The Cutting
cut the excess tube off
Step 4: More Cutting
cut three 8 inch pieces from the 2 foot peice
Step 5: Wrapping
wrap the three pieces in duct tape
Step 6: More Duct Tape
wrap the ends of the tubes in red duct tape
Step 7: Electrical Tape
stack the tubes into a pyramid and put black electrical tape around both ends
Step 8: The Card Board
get cardboard and cut a small section that your ipod will sit on then duct tape it to the other part
Step 9: Wires
get the controll panel out of the alar clock and tape it to the back and tape the wires to the front
Step 10: The App Store
go to the appstore and download the FREE app clocks! and include the exclamation point
Participated in the
Clocks Challenge