Homemade Bike Pusher Trailer 6.5hp

9,056

7

18

About: i am in school and i like to build things i prefer everything that has two wheels and most of my projects require the use of not many tools as i dont have a torch or a welder or a pipe bender

Intro: Homemade Bike Pusher Trailer 6.5hp

yep i finished the video tells all if you want detailed instructions just comment i am active on instructables 

Share

    Recommendations

    • Electronics Tips & Tricks Challenge

      Electronics Tips & Tricks Challenge
    • Plastics Contest

      Plastics Contest
    • Side Dishes Challenge

      Side Dishes Challenge

    18 Discussions

    0
    None
    ss127

    1 year ago

    please send me details on this cool build

    0
    None
    Rob builds

    2 years ago

    Can you please post some detailed design plans. Im 14 and im moving about 5 mins away from my garage and i need a way to get from my house to my garage. Please help.

    You can double your chance of winning by capitalizing your title :). It lets people know that you are professional. People who don't capitalize look like little kids.

    3 replies

    hahahahahhhahahahahhahahhahahahahhhhahahahahhahahahhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhaaaaaaaaaaaaaaaaaaaaaaaaaaaaa that is low- larious

    0
    None
    2 stroke

    7 years ago on Introduction

    where did you buy the throttle twist from the one on my motorized bike sticks on full sometimes its scary because that hing is fast so i have to twist it in the opposite direction to make it let go and now it broke because the cheap plastic crap snapped that hold the throttle cable thanks :P

    0
    None
    Hoopajoo

    7 years ago on Introduction

    Very cool! I'd love to see a video of how this does once it's opened all the way up. I've been considering fabricating a reverse trike (two front wheels) and mounting a trash-picked lawnmower engine to the front as a pull motor. I've read it is a far more efficient use of horsepower to pull a load rather than to push one (which is probably why most cars today are front wheel drive).

    5 replies
    0
    None
    HoopajooBIGHAIRYDUDE

    Reply 7 years ago on Introduction

    The plan I have devised in SketchUp calls for 2 similar bikes, some angle iron (usually available for free in the form of old, used bed rails), some bolts & nuts and a goodly amount of welding. As for the engine, I might follow your lead with a horizontal shaft motor instead of using the vertical shaft one I trash picked (I could chain link it to the front axle instead of direct gearing it as I was originally planning with the vertical shaft engine). The most difficult part is to engineer the rear-wheel steering (makes for some VERY tight turns).

    0
    None
    BIGHAIRYDUDEHoopajoo

    Reply 7 years ago on Introduction

    your doing rear wheel steering? well thats different i would like to see it in action when you finish

    0
    None

    I would love to see what you do with that, too!
    I have a similar project in mind... have a 4.5HP edger motor that I plan to use.

    0
    None
    BIGHAIRYDUDEHoopajoo

    Reply 7 years ago on Introduction

    hey i finished it all the way today and when i gunned it you can feel it 0-30 in less than two seconds, you have to lean forward when you hit the gas otherwise you'll do a wheelie